Idiots Guide to Easy Car Maintenance

Many people must find ways to enjoy life a little more frugally these days which invariably involves learning to do those little jobs around the house and on the auto which they employed to leave for the professionals.

Doing home maintenance on your motor really will help you to save money whilst keeping your car running in tip top condition which, in turn helps it to run more efficiently. It doesn’t require a car expert or even a “mechanical mind” to do many of these surprisingly easy maintenance jobs.

Windshield Wipers – these need changing every six months to a year depending upon the amount of use they’ve had and it truly is a surprisingly simple thing to do. Different cars do have slightly different wiper blade set ups however are all easy. All you have to do is to pop into your local auto parts store and buy some new wiper blades (they may be very affordable). Lift up the wipers on your windshield as if you were moving these to wash the glass, eliminate the old wiper blades (taking notice of how they were attached to the arms), then attach the latest blades. Most models have a tab about the lower side of the wiper which you simply push to get rid of the broken down blade.


If you get really stuck but believe me – brain surgery it ain’t, There’ll most likely be instructions around the wiper blade packaging!

Spark Plugs – these will most likely need to be replaced every 30,000 miles or so in fact it is remarkably easy and quick to do. You will need a spark plug socket having a socket extension but that’s it. It’s pretty simple to locate the spark plugs because they’ll be mounted on rubbery, thick wires. Your car may have four, six or eight depending upon the number of cylinders in your engine.


The important thing the following is not to remove all of the wires at once. These are in a specific order which cannot be changed so remove the first spark plug with your socket set and replace it. Tighten up the new spark plug by hand at first before using your wrench but don’t attempt to tighter it up a lot of. Then re attach the rubber wire and move on to the next spark plug until they have got all been changed.

Flushing Out the Radiator – this only takes around 30 minutes from beginning to end and can help to ensure that the cooling system on your motor works efficiently. Be sure that your vehicle engine is totally cool prior to starting then unscrew the drainage plug and allow the old coolant to drain out, then replace the plug and remove the cap at the top of the radiator. Add your radiator flushing means to fix your radiator (you’ll probably need to use a funnel) and top track of water for the required level. Replace the cap, start the engine and allow it to run until it reaches a normal temperature.


Before switching from the engine again and letting it cool, turn on the heater and leave it running for 10 minutes or so. Then drain the radiator once more and refill with a new coolant solution.

And that’s really all there is into it. Just tackling these few jobs yourself can help to save a few dollars occasionally. Alternatively you may pop into Nissan Ontario and permit them to do it for you. Check out their site at and you’ll see that they’ve got a terrific array of new and used cars too.

This entry was posted in Uncategorized. Bookmark the permalink.